Engine Check Light


How to Reset Your Check Engine Light | YourMechanic Advice
Engine Check Light

When driving your vehicle it is a good idea to scan your dashboard every so often, especially at a traffic light and when it is safe to do so. If you ever notice the - Engine Check Light come on, it either blinks or stays solid depending on the problem, either way, you need to have the vehicle checked by the mechanic. If the light is steady, it means that the problem is not an emergency, but it is a good idea to check your vehicle immediately.




Driving your car with your engine check light ON for an extended period of time, will cost you more in the long run. When the Engine Check light comes on, the car's E.F.I. goes into "LIMP" mode. LIMP mode means that the car becomes less dependent on input signals from sensors and runs off of pre-programmed parameters on the CPU which will help get you to the the nearest garage or destination without causing further damage to your vehicle.


AVTS launches Electronic Car Diagnostic check | AVTS


Before you take your car to a mechanic to have the issue with the engine check light resolved, it is important to get confirmation that the mechanic has a diagnostic tool to perform the checks specific to  your vehicle. The mechanic will need to interface with the cars E.F.I. either through a hand held device or laptop / tablet. This will allow him to see exactly which codes are coming up so he can further analyze the data and get to the root cause of the problem.


Top 5 Reasons Your Check Engine Light is On | Top Driver



There are five possible reasons why your engine check lights comes on, this should be used as a guide, only when the diagnostic is performed on the car's E.F.I. you can confirm.

  1. Failing Oxygen Sensor - Measures the Air/Fuel ratio through the exhaust and maintains optimum combustion.
  2. Bad Fuel - Water in fuel normally leads to something called  - Engine Knock or Engine pinging, this results from combustion taking place before the piston reaches Top Dead Center.
  3. Failing Mass Air Flow Sensor - Measure the amount of air flow that enters the engine.
  4. Damaged Spark Plugs or Wires - A damaged plug or wire can cause a leak in the electrical system that creates a ground fault.
  5. Damaged Catalytic Converter - The catalytic converter converts the toxic gases from combustion into a more environmentally friendly discharge from the vehicles exhaust.



3 comments:

Unknown said...

Thank for the information 👍😊

SHM said...

Very helpful and useful information. Thanks 👍

Naveer said...

Interesting read!