Brake Warning Light

What does it mean when the Brake Warning Light is ON?. This light could be on due to several reasons, the most common reason is as a result of you driving the vehicle with the braking system not fully disengaged. There are two types of braking system for when the car is parked, there is the Hand Brake and then there is the Floor Parking Brake.

Hand Brake should be completely lowered

Floor Parking Brake needs to be OFF

If the brake warning light comes on when you are mashing the brakes, then  this could be a sign that you are loosing hydraulic pressure in the braking system

Engine Check Light

Engine Check Light

When driving your vehicle it is a good idea to scan your dashboard every so often, especially at a traffic light and when it is safe to do so. If you ever notice the - Engine Check Light come on, it either blinks or stays solid depending on the problem, either way, you need to have the vehicle checked by the mechanic. If the light is steady, it means that the problem is not an emergency, but it is a good idea to check your vehicle immediately.

Driving your car with your engine check light ON for an extended period of time, will cost you more in the long run. When the Engine Check light comes on, the car's E.F.I. goes into "LIMP" mode. LIMP mode means that the car becomes less dependent on input signals from sensors and runs off of pre-programmed parameters on the CPU which will help get you to the the nearest garage or destination without causing further damage to your vehicle.

Before you take your car to a mechanic to have the issue with the engine check light resolved, it is important to get confirmation that the mechanic has a diagnostic tool to perform the checks specific to  your vehicle. The mechanic will need to interface with the cars E.F.I. either through a hand held device or laptop / tablet. This will allow him to see exactly which codes are coming up so he can further analyze the data and get to the root cause of the problem.

There are five possible reasons why your engine check lights comes on, this should be used as a guide, only when the diagnostic is performed on the car's E.F.I. you can confirm.

1. Failing Oxygen Sensor - Measures the Air/Fuel ratio through the exhaust and maintains optimum combustion.
2. Bad Fuel - Water in fuel normally leads to something called  - Engine Knock or Engine pinging, this results from combustion taking place before the piston reaches Top Dead Center.
3. Failing Mass Air Flow Sensor - Measure the amount of air flow that enters the engine.
4. Damaged Spark Plugs or Wires - A damaged plug or wire can cause a leak in the electrical system that creates a ground fault.
5. Damaged Catalytic Converter - The catalytic converter converts the toxic gases from combustion into a more environmentally friendly discharge from the vehicles exhaust.

Tune Ups

Car Tune-Up is really important in ensuring the longevity of you cars engine, all vehicles have a regular tune up schedule according to the O.E.M.( Original Equipment Manufacturer ) manual. The general rule of thumb is every 5000 km when using fully synthetic oil.

 

Tune-ups are to be considered as the preventative maintenance of your vehicle, which once done within the requirement of the O.E.M. recommendations, will save you  money and inconvenience of your car being down for extended periods of time. Based on the mileage of your vehicle, certain tune up services are required, these services range from just a oil and filter change to a change out of all fluids and belts for the engine and transmission

When your car is tuned up, the fuel consumption is reduced. A properly tuned vehicle will ensure complete combustion takes place during the power phase of the combustion process for the engine. Have the right amount of fuel and a strong source of ignition helps ensure the engine is being operated at its full capacity. Loss of power and increased gas consumption are both indicators that your car may require a tune-up.